VW Crafter / Man TGE windscreen covers are tailored to fit the factory plastics. The windscreen cover utilises the sun visors to support the cover, fold down to keep in place. Inside the vertical lines are 12 fiberglass rods used to eliminate sagging.  The vertical stich line on each side folds against the A-Pillar to further refine the fit. The top corners tuck up against the glass and headliner. 
 
Optional, to keep the center of the cover tight three magnets are included. tape or glue them in place behind the trim shown in the picture. Pulling on the top two corners will pop the clips from the top, a plastic trim tool is useful if struggling. DO NOT pull on the bottom edge these are sliding clips, once the top edge is released it will slide down towards the dash. 
 
If you have a factory or a slim rear view mirror the cover will go over the top. If it protrudes further than the split line of the trim shown a cut out can be done to your measurement. To check if it will clear run a straight line from the split line to where the glass meets the dash. Most dash cams will be fine.
 
LOW-E reflective insulation is used between the two layers UV resistant waterproof fabric, which blocks up to 97% of radiant heat. 
 
All of the campervan window covers are black on the exterior for a stealth appearance, please choose your interior colour. 
 
(For unique customized campervan window covers solution please contact Freddie at maverick overland).